I turn on this unit and it goes through its self check and stops at Please wait--B 06. What is indicated by this? Any tips as to what is happining or not happining would be greatly appreciated. Thank You--Dan
B6 Error is usually monitor cart not being fully booted.
Here is the list for B6
Incorrect Power Supply voltage
Connectors/Cables
Interconnect Cable
Fully Booted Monitor Cart
Serial Comm. ICs
Technique Processor
B6 Should be displayed on the Tech. Proc. Display
Good Luck!
Deon
Daniel Alandar
OEC 9400 "Please wait" B06
September 29, 2009 01:39
I turn on this unit and it goes through its self check and stops at Please wait--B 06. What is indicated by this? Any tips as to what is happining or not happining would be greatly appreciated. Thank You--Dan
to rate and post a comment
Deon Armes
Re: OEC 9400 "Please wait" B06
October 06, 2009 03:32
B6 Error is usually monitor cart not being fully booted.
Here is the list for B6
Incorrect Power Supply voltage
Connectors/Cables
Interconnect Cable
Fully Booted Monitor Cart
Serial Comm. ICs
Technique Processor
B6 Should be displayed on the Tech. Proc. Display
Good Luck!
Deon
to rate and post a comment