Issue with the boot sequence for a 9600. At first it would only boot to the end of the blocks,(no arrows)diagnosed it to be a SRAM issue. Replaced the technique processor, SRAM, and U20 EEPROM. Now it boots to three arrows and stops. Also replaced the EEPROM on the image function board with no change. I.F. fault light on image function stays lit at this point. I don't have the service software to check further. Any ideas?
Lightly used system available direct from the end user customer. MONARCH QUEST
Featuring our most advanced, data-driven navigation software with AI-Powered algorithms & advanced imaging integration with the GE HealthCare OEC 3D C-arm.
Charley Russell
OEC 9600 boot issue
June 10, 2016 04:50
Issue with the boot sequence for a 9600. At first it would only boot to the end of the blocks,(no arrows)diagnosed it to be a SRAM issue. Replaced the technique processor, SRAM, and U20 EEPROM. Now it boots to three arrows and stops. Also replaced the EEPROM on the image function board with no change. I.F. fault light on image function stays lit at this point. I don't have the service software to check further. Any ideas?
to rate and post a comment
Mario Mancha
re: OEC 9600 boot issue
May 10, 2017 09:55
did you solve it? Could you please help?
I'm having the same problem
to rate and post a comment