I am getting folowwing error messages when I run Diagnostics on boards.
1. System Interface Board.
Error -150 -MACRO FAIL - line 37 of C:\9800\DIAG SI\WS-PWR.MO1 Value contained in peak buffer if out of range.
2. Video Controller board.
Error -104 -MACRO FAIL -line 16 of C:\9800\DIAG\VC\TESTGAIN.MO1
ERROR COMPARING WORD VALUES.
3. Image Processor Board.
Error - 104 - MACRO FAIL - line 17 of
C:\9800\DIAG\IP\T2CMP1.MO1
Error comparing word values.
What is the significance of these error messages?
Machine functioning normally except for frequent booting problems.
Can anyone guide me.
Thank in advance.
R.Gopal
aparnaelectromech@gail.com
BMI-PMI services nearly every make, model, and modality through our nationwide team of nearly 200 local service engineers. Flexible contracts, 24/7 remote monitoring, and ISO 13485 certification. www.brownsmedicalimaging.com / 800-701-9729
R GOPAL
OEC 9800 ISSUES
April 03, 2017 01:24
Hi friends,
I am getting folowwing error messages when I run Diagnostics on boards.
1. System Interface Board.
Error -150 -MACRO FAIL - line 37 of C:\9800\DIAG SI\WS-PWR.MO1 Value contained in peak buffer if out of range.
2. Video Controller board.
Error -104 -MACRO FAIL -line 16 of C:\9800\DIAG\VC\TESTGAIN.MO1
ERROR COMPARING WORD VALUES.
3. Image Processor Board.
Error - 104 - MACRO FAIL - line 17 of
C:\9800\DIAG\IP\T2CMP1.MO1
Error comparing word values.
What is the significance of these error messages?
Machine functioning normally except for frequent booting problems.
Can anyone guide me.
Thank in advance.
R.Gopal
aparnaelectromech@gail.com
to rate and post a comment
Lenny Place
re: OEC 9800 ISSUES
April 04, 2017 11:10
Check the capacitors around the CPU IC on the SBC.
to rate and post a comment
CRAIG WAMBURA
re: OEC 9800 ISSUES
April 04, 2017 12:29
The run time errors are divided into four groups:
1. I/O errors - 100-149
2. Critical errors - 150-199
Error 150 is a critical error and 140 is an I/O error
I would first check the hard disk, replace it if faulty
If disk is ok, I would then perform a software reload because it seems the system cannot locate some files or write some files to the disk
to rate and post a comment
Zac Mountz
re: OEC 9800 ISSUES
April 04, 2017 12:33
Check the 5vdc power supply, adjust if needed. This causes a lot of issues.
to rate and post a comment