We are having problems with the column lift movement, sometimes it doesn't work going down. We check the pushbuttons and also the signals in the power motor realy board and it looks ok.
We think it could be a mechanical problem because if we pushed down the column when it is blocked it begins moving correctly.
Anybody has a clue?
The output of the relay board goes to a Gray Box on the lower left side of the C-arm mainframe. This is the power supply for the lift column. I would replace the power supply first.
The output of the relay board goes to a Gray Box on the lower left side of the C-arm mainframe. This is the power supply for the lift column. I would replace the power supply first.
Daniel Fernandez
OEC 9800 Vascular problem
March 02, 2007 06:02
We are having problems with the column lift movement, sometimes it doesn't work going down. We check the pushbuttons and also the signals in the power motor realy board and it looks ok.
We think it could be a mechanical problem because if we pushed down the column when it is blocked it begins moving correctly.
Anybody has a clue?
Thanks.
to rate and post a comment
Samuel Sandlin
Re: OEC 9800 Vascular problem
March 03, 2007 07:55
The output of the relay board goes to a Gray Box on the lower left side of the C-arm mainframe. This is the power supply for the lift column. I would replace the power supply first.
to rate and post a comment
Samuel Sandlin
Re: OEC 9800 Vascular problem
March 03, 2007 08:03
The output of the relay board goes to a Gray Box on the lower left side of the C-arm mainframe. This is the power supply for the lift column. I would replace the power supply first.
to rate and post a comment