Hi Colleagues ,
I have one old BV 25 (not 25N or 25S or 25HR...)and get the following problem:
When switching on ,the on button remains flashing which means no X-ray and not ready situation.
I have only the LEDs with H1-H18 at the SE15 or H1-H6 and H11-H18 ,all of them are ok according to the manual.Also the LED array for Flouro is OK.,also the display of 40 KV,0.2mAs is OK.The 15cm Cascade generator is also checked and ok.If the II get a problem with high current,the H2 must lit which is not .I changed some PCBs Like:
The SB1,the SE 11,the SE17 with no result.Still the on button flashing all the time.
The console is not the type that you can get some error numbers -it is at another models.
Any help will be appreciated.Thanks.
Marwan Kumsie
My E-mail
maruan@novamedicalbg.com
When I disconnected the video cable from the camera the same happened to me(flashing led). I do not know which model was though worth trying to check the camera and connections on your system. Power supplies of the camera?
Lightly used system available direct from the end user customer. MONARCH QUEST
Featuring our most advanced, data-driven navigation software with AI-Powered algorithms & advanced imaging integration with the GE HealthCare OEC 3D C-arm.
Marwan Kumsie
Philips BV 25 problem
October 02, 2014 10:26
Hi Colleagues ,
I have one old BV 25 (not 25N or 25S or 25HR...)and get the following problem:
When switching on ,the on button remains flashing which means no X-ray and not ready situation.
I have only the LEDs with H1-H18 at the SE15 or H1-H6 and H11-H18 ,all of them are ok according to the manual.Also the LED array for Flouro is OK.,also the display of 40 KV,0.2mAs is OK.The 15cm Cascade generator is also checked and ok.If the II get a problem with high current,the H2 must lit which is not .I changed some PCBs Like:
The SB1,the SE 11,the SE17 with no result.Still the on button flashing all the time.
The console is not the type that you can get some error numbers -it is at another models.
Any help will be appreciated.Thanks.
Marwan Kumsie
My E-mail
maruan@novamedicalbg.com
to rate and post a comment
Tibor Ivanszky
re: Philips BV 25 problem
October 03, 2014 10:14
When I disconnected the video cable from the camera the same happened to me(flashing led). I do not know which model was though worth trying to check the camera and connections on your system. Power supplies of the camera?
to rate and post a comment
Daniel Fernandez
re: Philips BV 25 problem
October 03, 2014 10:20
Did you check the cable which connects the C arm with the monitors?
I had many different problems with this cable.
Good luck!
to rate and post a comment