Ampronix, a Top Master Distributor for Sony Medical, provides Sales, Service & Exchanges for Sony Surgical Displays, Printers, & More. Rely on Us for Expert Support Tailored to Your Needs. Email info@ampronix.com or Call 949-273-8000 for Premier Pricing.
Alessandro Lazzari
Philips Intera 1,5T
September 09, 2011 10:29
I am looking for installation planning for philips intera 1,5T in order to evaluate size of available rooms, also a single page with a standard installation will be helpfull, many thanks.
to rate and post a comment
Milner A. Flecha
Re: Philips Intera 1,5T
September 09, 2011 11:00
Give me your e-mail.
I will send you the info.
Regards
to rate and post a comment
Eng.Muhanned Ahmed
Re: Philips Intera 1,5T
November 30, 2011 11:42
Dear Mr.Milner
i need the service manual for MRI Philips 1.5 T can you provide it ?
Thank you
to rate and post a comment
Leonardo Alcantara
re: Re: Philips Intera 1,5T
July 21, 2015 07:50
Can I have one copy?
leonardomacedoalcantara@gmail.com
to rate and post a comment
Juan Ramirez
re: Re: Philips Intera 1,5T
December 09, 2016 08:48
Hi Milner, I hope everything is going ok in your life.
I wish ask you for help with this...
The secuence of events was: We were using a knee coil and didn't work because it didn't recognice the the connector A. The coil was connected in other conector and the cable was changed but the message was the same, so it was necessary to use another coil. Days before the coils were failing too.
Some hours after when the MRI was taking a exam of cervical spine, the MRI was in silence for around 1 minute like if that was not working and show a message asking for to connect the coil again, the operators connected the coil again and the MRI was working again.
3 hours after the MRI didn't work and shows two messages:
1. Cannot determine optimun RF power
2. Cannot determine resonance frequency, no signal at all.
We turned off the power of the RF and gradients and we cleaned the dust inside and the connectors with electronic cleaner, no more and after we tried to start again, but the message was the same.
to rate and post a comment
Juan Ramirez
re: Re: Philips Intera 1,5T
December 09, 2016 08:48
Dear Milner i hope everything is going ok in your life, i woul like to know if you can help me with this problem or if you can share with me the Service Manua of Intera 1,5T Philips
The secuence of events was: We were using a knee coil and didn't work because it didn't recognice the the connector A. The coil was connected in other conector and the cable was changed but the message was the same, so it was necessary to use another coil. Days before the coils were failing too.
Some hours after when the MRI was taking a exam of cervical spine, the MRI was in silence for around 1 minute like if that was not working and show a message asking for to connect the coil again, the operators connected the coil again and the MRI was working again.
3 hours after the MRI didn't work and shows two messages:
1. Cannot determine optimun RF power
2. Cannot determine resonance frequency, no signal at all.
We turned off the power of the RF and gradients and we cleaned the dust inside and the connectors with electronic cleaner, no more and after we tried to start again, but the message was the same.
to rate and post a comment
Chuck Miles
Re: Philips Intera 1,5T
September 09, 2011 01:42
Have you looked at the Philips Healthcare website? They have pretty good room layout info
http://www.healthcare.philips.com/us_en/support/siteplanning/index.wpd
to rate and post a comment
Carlos Carrillo
Re: Philips Intera 1,5T
September 12, 2011 12:09
this is a tipical instalacion
to rate and post a comment
Carlos Carrillo
Re: Philips Intera 1,5T
September 12, 2011 12:09
i need your email adrres I Have a typical drawing
to rate and post a comment
Alessandro Lazzari
Re: Philips Intera 1,5T
September 15, 2011 10:24
my email address to send layout is tecnoray@inwind.it many thanks
to rate and post a comment