I am getting the following error when booting up the tower "Could not
start application, because of application software inconsistency".
With C-Arm connected I get an M050 error on it but i belive it is caused by the DFI software not booting up on the tower. (DFI software version 2.2.4 data 23 july 2007).
The problem is software?
I need the procedure reloading software and service manual.
Any info would be
greatly appreciated.
Eduardo
BRAZIL
eduardo@elomed.com.br
The coaxial pins in the stand connector were in short, eliminate this short circuit and the fail dissappears then change the cable, is expensive but is the solutions
Ophthalmic-focused expertise in YAG systems including repair, maintenance and calibration handled with precision by trained professionals. Request service • sales@laserlocators.com • 1-877-924-2020
Eduardo Tognon
Philips-BV Endura M050 Error Code
February 05, 2011 05:11
I am getting the following error when booting up the tower "Could not
start application, because of application software inconsistency".
With C-Arm connected I get an M050 error on it but i belive it is caused by the DFI software not booting up on the tower. (DFI software version 2.2.4 data 23 july 2007).
The problem is software?
I need the procedure reloading software and service manual.
Any info would be
greatly appreciated.
Eduardo
BRAZIL
eduardo@elomed.com.br
to rate and post a comment
LUIS RIVAS
re: Philips-BV Endura M050 Error Code
July 02, 2013 06:01
hello you solve your problem with endura error m050, I have the same error, can you help me
to rate and post a comment
LUIS RIVAS
re: re: Philips-BV Endura M050 Error Code
September 04, 2014 10:18
Yes was the coaxil cable within the cable to connect the trolley with stand
to rate and post a comment
Miguel Torres
re: re: Philips-BV Endura M050 Error Code
March 22, 2019 10:44
I have the same error in pulsera c arm could you help me
Wath means this error?!
to rate and post a comment
G. John Oggel
re: Philips-BV Endura M050 Error Code
September 03, 2014 09:00
Hello,
did you figure out how to fix this error code? I have a philips BV-Endura that has the same code...can you help me?
to rate and post a comment
LUIS RIVAS
re: re: Philips-BV Endura M050 Error Code
September 05, 2014 09:38
The coaxial pins in the stand connector were in short, eliminate this short circuit and the fail dissappears then change the cable, is expensive but is the solutions
to rate and post a comment
hiortsam dade
re: Philips-BV Endura M050 Error Code
January 11, 2019 09:51
Please whats the part number of this cable?
to rate and post a comment