We offer reliable & cost-effective spare parts for the Philips Achieva 1.5T MRI system helping you minimize downtime & keep operations smooth. Wide inventory available. Quick turnaround time. Expert support. Worldwide delivery. Contact Limor@elsmed.com
Picker Eclipse 6U 9U interface problem
June 01, 2012 08:53
Hi to everybody;
I have a problem on Picker Eclipse MRI.I am writing Xterm fault line ;
-scan pmc6u9u:3 pciFindDevice failed;could not find 6U to 9U interface PMC PCI bus.
-scan bpbInitLib:3 Unsupported access interrupt detected ;expected timeout/no response type.
-scan S_feiInitLib_ILLEGAL_BACKPLANE_BUS_ACCESS
system logging to scan,recon,pap0,pap1 and system loading PGR but not logging to FEI server.
Do you have any experience about this topic?
Best Regards
to rate and post a comment
Wojciech Selwesiuk
re: Picker Eclipse 6U 9U interface problem
June 02, 2012 03:38
Hi,
PGR, scan, recon, pap are parts of 6U section. FEI - Front End Interface is a board from 9U. From first view it is like a not working 9U section (Power Supply?). Check the LEDs on the front panel and leds on the 9U boards. Possible faulty PS.
to rate and post a comment
Sanchez Navarro
re: re: Picker Eclipse 6U 9U interface problem
June 04, 2012 09:25
Thanks for reply dear Selwesiuk,9U PS leds are on,also i replaced a new one 18V PS but problem is still there.I replaced 9U backplane board,Data Engine,TR interface but problem is didnt change..
to rate and post a comment
Wojciech Selwesiuk
re: re: re: Picker Eclipse 6U 9U interface problem
June 04, 2012 02:46
PS provides +5v, -18v and +18vdc.
9U clock is derived from Exciter board (under the 9u unit). Check the PS for Exciter/Receiver section - leds should be on - on the left side of the boards.
Make photos of the any visible leds and 6u and 9u boards and send me to analyze (wselwesiuk@synektik.com.pl)
to rate and post a comment
Sanchez Navarro
re: re: re: re: Picker Eclipse 6U 9U interface problem
June 05, 2012 09:26
All scan/recon PS leds are on Mr Selwesiuk,but i didint check to exciter cables connection.If you want to see photos of Scan/recon,i will send.
Thanks
to rate and post a comment
Wojciech Selwesiuk
re: re: re: re: re: Picker Eclipse 6U 9U interface problem
June 06, 2012 09:10
OK, send me
to rate and post a comment