Hello everyone,
I’m looking for technical manuals and installation documentation for a Picker Proview 0.23T MRI system (permanent magnet).
Specifically, I’m interested in:
Installation and setup procedures
Passive shimming specifications
The tools to perform shimming properly
Any help, documentation, or contact references would be greatly appreciated.
I’m also open to recommendations of technicians with experience on this model.
I have documetation for such system so I can share. Also with instalaltion work instruction.
I am afraid original shimming procedure can be difficult because no accessibility of the tools (Field camera). I asked for complete instalaltion a company form Turkey where they did complete calibrations after my mechanical and electrical assembly.
I see Craig Wambura offered his help so may it it better option.
Ophthalmic-focused expertise in YAG systems including repair, maintenance and calibration handled with precision by trained professionals. Request service • sales@laserlocators.com • 1-877-924-2020
Eduardo Cerini
Picker proview installation
August 08, 2025 05:40
Hello everyone,
I’m looking for technical manuals and installation documentation for a Picker Proview 0.23T MRI system (permanent magnet).
Specifically, I’m interested in:
Installation and setup procedures
Passive shimming specifications
The tools to perform shimming properly
Any help, documentation, or contact references would be greatly appreciated.
I’m also open to recommendations of technicians with experience on this model.
Thanks in advance!
to rate and post a comment
CRAIG WAMBURA
re: Picker proview installation
August 11, 2025 11:33
I can help
to rate and post a comment
Wojciech Selwesiuk
re: Picker proview installation
August 18, 2025 12:48
I have documetation for such system so I can share. Also with instalaltion work instruction.
I am afraid original shimming procedure can be difficult because no accessibility of the tools (Field camera). I asked for complete instalaltion a company form Turkey where they did complete calibrations after my mechanical and electrical assembly.
I see Craig Wambura offered his help so may it it better option.
to rate and post a comment