thanks for your help, i note that the stop switch was bad, i fixed so i have no more this problem
but i have a new problem, that when i try to make exposure in the begining from the expousure i get Err33, can you help me also with this?? thanks again, i am new with this system.
Er 33 Tube filament control inoperative.
Go to Service mode.
For service mode press Ctrl and Ceph key for 6Seconds
after this press CTRL -B and hold exposure switch for 4 seconds untill exposure end
DirectMed Imaging specializes in Equipment Sales, Parts, and Support. Parts are in stock and available for immediate delivery. In-room MRI Upgrades are available now. (855) 463-3727 or sales@directmedimaging.com
Christian von leipzig
Planmeca PM2002 Error
September 24, 2009 12:07
Hello i need some help how to solve Err 53 in the planmeca Pm2002 Orthopantomograph. thanks for helping me
to rate and post a comment
Mario Mancha
Re: Planmeca PM2002 Error
September 24, 2009 12:36
ER 53 UP/DOWN MOTOR DOES NOT CONSUME POWER
SEEMS LIKE MOTOR DISCONNECTED OR BAD MOTOR
HOPE IT HELPS
to rate and post a comment
Christian von leipzig
Re: Planmeca PM2002 Error
September 25, 2009 09:08
thanks for your help, i note that the stop switch was bad, i fixed so i have no more this problem
but i have a new problem, that when i try to make exposure in the begining from the expousure i get Err33, can you help me also with this?? thanks again, i am new with this system.
to rate and post a comment
Mazher saeed
re: Re: Planmeca PM2002 Error
February 03, 2015 10:34
Er 33 Tube filament control inoperative.
Go to Service mode.
For service mode press Ctrl and Ceph key for 6Seconds
after this press CTRL -B and hold exposure switch for 4 seconds untill exposure end
to rate and post a comment
issam radjah
re: re: Re: Planmeca PM2002 Error
August 30, 2015 01:24
I have the same problem can somebody help me !!
to rate and post a comment
issam radjah
re: re: Re: Planmeca PM2002 Error
August 30, 2015 01:24
I have the same problem can somebody help me
to rate and post a comment