Cleaning the Rollers
Introduction
Periodically clean the rollers to remove dust and small particles. The roller-cleaning device enables you to clean the
rollers that feed the screen from the cassette into the unit.
The cleaning device includes the following items:
• Cleaning tray
• Cleaning plate with adhesive strips covered with protective paper/a protective envelope
Using the Cleaning Plate to Clean the Rollers
[1] Remove any cassettes and screens from the unit.
[2] Open the Kodak QC software.
[3] In the User Interface, click [Setup].
[4] Click [Login]
The “User” screen opens.
User Tab
[5] In the “User” tab, click [Prepare].
The following
message appears.
SERVICE GUIDE
76 10APR2006 – Catalog No. 6H1344
Insert Cleaning Tray Message
[6] Insert the Cleaning Tray, making sure that it locks in place.
[7] Click [OK].
The rollers begin to turn.
Removing the Protective Strips
[8] Remove the protective paper from the cleaning plate to expose the adhesive.
Preventive Maintenance
Catalog No. 6H1344 – 10APR2006 77
Inserting the Cleaning Tray
[9] Place the Cleaning Plate on the tray. Make sure the Cleaning Plate is placed in the correct direction, as specified
on the plate.
[10] While holding onto the plate, push the plate slightly into the unit. It should go in almost entirely, with
approximately ¼ remaining outside
The following message appears:
Pull Out Cleaning Plate Message
[11] Click [OK] and remove the plate.
give me one email for send you picture on cleaning rollers....
Y.
HIGH QUALITY fully tested & refurbished systems to manufacturer specifications like new. Installation & service support worldwide. Parts & tubes in stock with warranty. Sales@Elsmed.com
Ray Molleson
POC rollers
December 30, 2011 11:08
Does any one know what works best for cleaning the rubber rolers on Orex/POC CR units?
to rate and post a comment
yamil sanchez
Re: POC rollers
December 31, 2011 02:15
Cleaning the Rollers
Introduction
Periodically clean the rollers to remove dust and small particles. The roller-cleaning device enables you to clean the
rollers that feed the screen from the cassette into the unit.
The cleaning device includes the following items:
• Cleaning tray
• Cleaning plate with adhesive strips covered with protective paper/a protective envelope
Using the Cleaning Plate to Clean the Rollers
[1] Remove any cassettes and screens from the unit.
[2] Open the Kodak QC software.
[3] In the User Interface, click [Setup].
[4] Click [Login]
The “User” screen opens.
User Tab
[5] In the “User” tab, click [Prepare].
The following
message appears.
SERVICE GUIDE
76 10APR2006 – Catalog No. 6H1344
Insert Cleaning Tray Message
[6] Insert the Cleaning Tray, making sure that it locks in place.
[7] Click [OK].
The rollers begin to turn.
Removing the Protective Strips
[8] Remove the protective paper from the cleaning plate to expose the adhesive.
Preventive Maintenance
Catalog No. 6H1344 – 10APR2006 77
Inserting the Cleaning Tray
[9] Place the Cleaning Plate on the tray. Make sure the Cleaning Plate is placed in the correct direction, as specified
on the plate.
[10] While holding onto the plate, push the plate slightly into the unit. It should go in almost entirely, with
approximately ¼ remaining outside
The following message appears:
Pull Out Cleaning Plate Message
[11] Click [OK] and remove the plate.
give me one email for send you picture on cleaning rollers....
Y.
to rate and post a comment