I have a problem with a Polydoros sx 65. It doesn´t complete the start up process. The display in D100 remains in "1" (waiting for network connection) and the leds indicators SPC "tx rx" in the XCU doesn´t blink. Does anyone have an opinion about this problem?
Terminate communication ports with 120 Ohms resistors on D320 and see if the generator becomes ready. This way you understand if error comes from external device.
Also, you can connect monitor and keyboard to the XCU and see if the pc is booting normally. There is a battery also in the XCU which must be replaced regularly.
The ready state of D320 is 0.0. and the decimals must flash if i remember well.Other states have error explanation as well.
If you replace CMOS battery you must configure the XCU CMOS >boot without keyboard
BMI-PMI services nearly every make, model, and modality through our nationwide team of nearly 200 local service engineers. Flexible contracts, 24/7 remote monitoring, and ISO 13485 certification. www.brownsmedicalimaging.com / 800-701-9729
EFREN FRANCO
Polydoros sx 65 doesn´t start up
June 25, 2013 08:11
I have a problem with a Polydoros sx 65. It doesn´t complete the start up process. The display in D100 remains in "1" (waiting for network connection) and the leds indicators SPC "tx rx" in the XCU doesn´t blink. Does anyone have an opinion about this problem?
to rate and post a comment
Lenny Place
re: Polydoros sx 65 doesn´t start up
June 26, 2013 10:10
sounds like a XCU issue possibly bad hard drive. do you have a a XCU boot disk you can see if the system will bootup with floppy in the drive?
to rate and post a comment
Dante Nuevo
re: Polydoros sx 65 doesn´t start up
June 26, 2013 10:10
Contact me. I can help you.
Dante Nuevo
dantenuevo@hotmail.com
to rate and post a comment
ADRIAN GUTIERREZ
re: Polydoros sx 65 doesn´t start up
June 26, 2013 10:17
look for some info on smstechforum.com they help me a lot.
to rate and post a comment
EFREN FRANCO
re: re: Polydoros sx 65 doesn´t start up
June 27, 2013 12:40
thank you for the information.
to rate and post a comment
Tibor Ivanszky
re: Polydoros sx 65 doesn´t start up
June 26, 2013 10:28
Terminate communication ports with 120 Ohms resistors on D320 and see if the generator becomes ready. This way you understand if error comes from external device.
Also, you can connect monitor and keyboard to the XCU and see if the pc is booting normally. There is a battery also in the XCU which must be replaced regularly.
to rate and post a comment
Tibor Ivanszky
re: Polydoros sx 65 doesn´t start up
June 26, 2013 10:39
The ready state of D320 is 0.0. and the decimals must flash if i remember well.Other states have error explanation as well.
If you replace CMOS battery you must configure the XCU CMOS >boot without keyboard
to rate and post a comment
Tibor Ivanszky
re: Polydoros sx 65 doesn´t start up
June 26, 2013 10:39
The SPC tx/rx is indicative when you connect service PC with the siemens software.
to rate and post a comment
EFREN FRANCO
re: re: Polydoros sx 65 doesn´t start up
June 27, 2013 12:40
thank you for your reply. I'll try to find out something with these comments.
to rate and post a comment