We have a defective Laser Camera Digital Interface PCB of a PQ2000 CT Scanner.An IC on this PCB (U125 in schematics),PALCE22V10 is secured by the company and is not giving permission to copy.
Would you please lead as,for solutions to copy this IC or to do something else.
We have had to replace pcb, in the past. Were using a Kodak laser. Found that our real problem was the 100ft+ length, caused errors. have 3 or 4 of those boards now, but since changed over to dryview. IC were too hard to come by.
Some cameras has an analog video input. If it is your case you only need to use a good quality splittter in the green video line that go to the monitor. the camera will "see" the same image you are seeing on monitor. You only need to try.
BMI-PMI services nearly every make, model, and modality through our nationwide team of nearly 200 local service engineers. Flexible contracts, 24/7 remote monitoring, and ISO 13485 certification. www.brownsmedicalimaging.com / 800-701-9729
Selcuk Akin
PQ2000 Laser Camera Digital Interface problem
September 08, 2008 03:20
We have a defective Laser Camera Digital Interface PCB of a PQ2000 CT Scanner.An IC on this PCB (U125 in schematics),PALCE22V10 is secured by the company and is not giving permission to copy.
Would you please lead as,for solutions to copy this IC or to do something else.
Best regards
to rate and post a comment
Richard McCrocklin
Re: PQ2000 Laser Camera Digital Interface problem
September 08, 2008 11:14
We have had to replace pcb, in the past. Were using a Kodak laser. Found that our real problem was the 100ft+ length, caused errors. have 3 or 4 of those boards now, but since changed over to dryview. IC were too hard to come by.
to rate and post a comment
Zhou Aiming
Re: PQ2000 Laser Camera Digital Interface problem
September 09, 2008 04:32
I can supply it for you,but it would be expensive.
to rate and post a comment
Jose Morillo
Re: PQ2000 Laser Camera Digital Interface problem
September 10, 2008 03:11
Some cameras has an analog video input. If it is your case you only need to use a good quality splittter in the green video line that go to the monitor. the camera will "see" the same image you are seeing on monitor. You only need to try.
to rate and post a comment