Dear all,
i had a defective power supply at HD 11, it was occured by some defective capacitors. C616 and 617, 200V, 470µF were defective, i made all new on the left board (seen from behind).
The Power-Supply runs now.
But i have still a problem: it only starts when i cancel the connection from pc to the left US-Board
(orage clips). Otherwise it shuts down immediatelly when start, the green AC-ligt goes of. If i cancel the connection an give ac to the monitor, the system starts up, the HD11 software is shown. Now i can connect while running the system. all lights on power-supply go on and if i then restart the system, it works fine.
Please can somebody help me? Do somebody know the maintenance password? Its very urgently! Thanks for your help! Holger
We are the best choice for all your Endoscopy needs. We have Certified Pre-Owned refurbished and used Endoscopes, and all other related components and
accessories. We are committed to your absolute satisfaction. (513) 469-7267
Holger Fritze
Problem Philips HD11 V1.07, password needed
June 07, 2011 04:20
Dear all,
i had a defective power supply at HD 11, it was occured by some defective capacitors. C616 and 617, 200V, 470µF were defective, i made all new on the left board (seen from behind).
The Power-Supply runs now.
But i have still a problem: it only starts when i cancel the connection from pc to the left US-Board
(orage clips). Otherwise it shuts down immediatelly when start, the green AC-ligt goes of. If i cancel the connection an give ac to the monitor, the system starts up, the HD11 software is shown. Now i can connect while running the system. all lights on power-supply go on and if i then restart the system, it works fine.
Please can somebody help me? Do somebody know the maintenance password? Its very urgently! Thanks for your help! Holger
to rate and post a comment