I will try to replace the display controler but I have to locate it first on the machine .here I have to do everything because there is no biomed availlable.
You can locate the board by opening the plastic front cover, two screws holding it, then remove the metal cover with six screws. The board is the second from the left marked A14. Pull it out.
great news -I found it and remove the board - it had multiple removable chips ont- I removed each one cleaning the tip and puting them back- results: Full display-crsper I ever had on that machine-
Thanks again
now I also saw an audio video module on top but there is no BNC video out on it . How do I add a black and white printer in this case? do I use the paralel data?
Thanks
Check the back of the machine, but if it is not there, then open the back at the top of the main cover by removing two screws which would let you have access to where the printer is to take its power supply from.
If you could not find the BNC cable and connector there, then use female adapter for the video side of the audio/video module. I hope it works.
Garald jean louis
problem with ATL 4 no display
April 18, 2008 08:26
the system turns on but no dsplay of the ultrasound -help needed please
thanks
Garald Ivan JEN-LOUIS, MD
to rate and post a comment
Augustine Kobla Amenyo
Re: problem with ATL 4 no display
April 19, 2008 01:23
Is the monitor on? Is there grayscale? Adjust the brightness and the contrast.
Let me hear from you.
to rate and post a comment
Garald jean louis
Re: problem with ATL 4 no display
April 19, 2008 04:28
monitor is on but no gray scale at all- I suppose it would be a software problem whyle the machine is booting
to rate and post a comment
Augustine Kobla Amenyo
Re: problem with ATL 4 no display
April 21, 2008 01:03
If you have the display controller (A14) pcb you can replace it. I hope it will work.
to rate and post a comment
Garald jean louis
Re: problem with ATL 4 no display
April 21, 2008 03:38
I will try to replace the display controler but I have to locate it first on the machine .here I have to do everything because there is no biomed availlable.
to rate and post a comment
Augustine Kobla Amenyo
Re: problem with ATL 4 no display
April 22, 2008 02:54
You can locate the board by opening the plastic front cover, two screws holding it, then remove the metal cover with six screws. The board is the second from the left marked A14. Pull it out.
to rate and post a comment
Garald jean louis
Re: problem with ATL 4 no display
April 22, 2008 09:00
great news -I found it and remove the board - it had multiple removable chips ont- I removed each one cleaning the tip and puting them back- results: Full display-crsper I ever had on that machine-
Thanks again
now I also saw an audio video module on top but there is no BNC video out on it . How do I add a black and white printer in this case? do I use the paralel data?
Thanks
to rate and post a comment
Augustine Kobla Amenyo
Re: problem with ATL 4 no display
April 24, 2008 02:58
Check the back of the machine, but if it is not there, then open the back at the top of the main cover by removing two screws which would let you have access to where the printer is to take its power supply from.
If you could not find the BNC cable and connector there, then use female adapter for the video side of the audio/video module. I hope it works.
to rate and post a comment