Please check these:
Some times swconfig run automatic without you note and just show a line on top that say time is elapsed and automatic run is proceding.
other case is when you change the microprocessor Ic for another from other equipment or use a pity that is for another equipment with another configuration.
i do not why but these cause swconfig doesn make changes when you insert or retire boards
Lightly used system available direct from the end user customer. MONARCH QUEST
Featuring our most advanced, data-driven navigation software with AI-Powered algorithms & advanced imaging integration with the GE HealthCare OEC 3D C-arm.
Abdula Saeed El Shafeey
Problem with Picker model PQ6000
January 09, 2010 11:38
When I write the command " swconfig" and reboot the system , the command doesn't execute .
I replaced the cpu board and the system monitor board but the problem still there .
What is your suggestion ?
to rate and post a comment
Wojciech Laniecki
Re: Problem with Picker model PQ6000
January 11, 2010 09:27
As far as I know the only option is to reload the system software.
to rate and post a comment
Jose Morillo
Re: Problem with Picker model PQ6000
January 11, 2010 09:27
Please check these:
Some times swconfig run automatic without you note and just show a line on top that say time is elapsed and automatic run is proceding.
other case is when you change the microprocessor Ic for another from other equipment or use a pity that is for another equipment with another configuration.
i do not why but these cause swconfig doesn make changes when you insert or retire boards
to rate and post a comment