I have a BV 29 with problems: first it didn't have any image, and both monitors had bad image with vertical movement. I changed the the plastic cable on the intensifier camera and the problem was solved. Then I was making a lot of probes and it was fine. After that the personal reported that the equipment suddenly turned off, when I check the equipment I turned on, the scopofix turned on and the right monitor only appears the hospital data and in the c-arm displays didn't appears anything, then I turned off the equipment I waited a moment and turned on again an this time all was normal, i was making shoots and fluoro. It was running about 3 hours continously, but when we traied to turned on after that again only the right monitor with hospital data. Turned off after a moment turned on and again all was normal.
Anybody have a idea that can be happening?
thanks
HIGH QUALITY fully tested & refurbished systems to manufacturer specifications like new. Installation & service support worldwide. Parts & tubes in stock with warranty. Sales@Elsmed.com
Emanuel Carmona
Problems with BV 29 C-arm
May 30, 2009 02:55
I have a BV 29 with problems: first it didn't have any image, and both monitors had bad image with vertical movement. I changed the the plastic cable on the intensifier camera and the problem was solved. Then I was making a lot of probes and it was fine. After that the personal reported that the equipment suddenly turned off, when I check the equipment I turned on, the scopofix turned on and the right monitor only appears the hospital data and in the c-arm displays didn't appears anything, then I turned off the equipment I waited a moment and turned on again an this time all was normal, i was making shoots and fluoro. It was running about 3 hours continously, but when we traied to turned on after that again only the right monitor with hospital data. Turned off after a moment turned on and again all was normal.
Anybody have a idea that can be happening?
thanks
Best regards
to rate and post a comment