I have problems with a x-ray equipment, in the control console after switch on appears " 00L2 press reset", I just press reset from the console and the main board, but nothin happends, somebody tell me that is possible that this equipment has a trouble with the rotor controller, but I don't know where is it.
hello Emanuel,
i have this manual for optimus 50 x ray generator, i do not know if you have accesed the x program for checking the machine otheriwse you will need the software, i think i have this info.
please contact me.
annorys1971@att.net.mx
Ophthalmic-focused expertise in YAG systems including repair, maintenance and calibration handled with precision by trained professionals. Request service • sales@laserlocators.com • 1-877-924-2020
Emanuel Carmona
Problems with OPTIMUS 50
January 05, 2010 12:35
Hi everyone:
I have problems with a x-ray equipment, in the control console after switch on appears " 00L2 press reset", I just press reset from the console and the main board, but nothin happends, somebody tell me that is possible that this equipment has a trouble with the rotor controller, but I don't know where is it.
Anybody can tell me how can I find this???
Somebody have the service manual????
Thanks
Best regards
to rate and post a comment
Jose Vallejos
Re: Problems with OPTIMUS 50
January 06, 2010 10:43
Hi you problem is :
00L2 ERROR GC: Data access error
I have a complete set of service manuals and software for Optimus 50 Rad and R/F.
javv2010@live.cl
to rate and post a comment
Hipolito Jorge Iglesias
Re: Problems with OPTIMUS 50
January 07, 2010 09:55
hello Emanuel,
i have this manual for optimus 50 x ray generator, i do not know if you have accesed the x program for checking the machine otheriwse you will need the software, i think i have this info.
please contact me.
annorys1971@att.net.mx
to rate and post a comment