I have 0.2T Signa EXCITE, Iam having a problem with the RF, during scanning the RF goes and the error messages shows (RF Recovery in progress) we did fine tunning for the coil and we did Gain calibration test, but when the RF goes the fans of the RF Amplifier stop, after one minute the RF Amplifier goes back to ready state and we can continue the scan, but recently the RF issue if tooooo frequent and some system cant work anymore. Any one can give me the suspected fault? Thank you
Either the input power to the RF amplifier is not secure or, the power supplies in the RF amplifier are going bad. We can repair the amplifier for you. bruce@medsystech.com
Nuhad Salman
RF Problem
April 13, 2017 10:43
I have 0.2T Signa EXCITE, Iam having a problem with the RF, during scanning the RF goes and the error messages shows (RF Recovery in progress) we did fine tunning for the coil and we did Gain calibration test, but when the RF goes the fans of the RF Amplifier stop, after one minute the RF Amplifier goes back to ready state and we can continue the scan, but recently the RF issue if tooooo frequent and some system cant work anymore. Any one can give me the suspected fault? Thank you
to rate and post a comment
Gabriel Cool
re: RF Problem
April 14, 2017 06:03
What is the error logs? Did you make nanual prescan?
to rate and post a comment
Bruce Smith
re: RF Problem
April 16, 2017 08:44
Either the input power to the RF amplifier is not secure or, the power supplies in the RF amplifier are going bad. We can repair the amplifier for you. bruce@medsystech.com
to rate and post a comment
INOWER
re: RF Problem
April 25, 2017 08:19
It seems like it is related to RF amp Share any error logs if possible. Can support you to rectify the problem.
inowerelectricals@gmail.com
to rate and post a comment