Power up from cold produces error message "thermal or door over". After several off/on switches the unit powers up ok and runs ok all day. Suspect power supply in console. Any help much appreciated.
DirectMed Imaging specializes in Equipment Sales, Parts, and Support. Parts are in stock and available for immediate delivery. In-room MRI Upgrades are available now. (855) 463-3727 or sales@directmedimaging.com
harry fletcher
shimadzu ud-150b-10 error message
October 14, 2009 10:17
Power up from cold produces error message "thermal or door over". After several off/on switches the unit powers up ok and runs ok all day. Suspect power supply in console. Any help much appreciated.
to rate and post a comment
Carlos Duran
Re: shimadzu ud-150b-10 error message
October 27, 2009 02:04
UD console rack has a terminal strip to mount SW's to inhibit Xray; check that conections on DOOR and SW on the terminal board.
cordially,
carlos
to rate and post a comment
Russell Wake
re: shimadzu ud-150b-10 error message
December 11, 2012 12:29
hello would any one no what E6 error on a shimadzu ud-150 l-f be
to rate and post a comment
Russell Wake
re: re: shimadzu ud-150b-10 error message
December 11, 2012 01:57
sorry its f6 not e6
to rate and post a comment
Jose Vallejos
re: re: re: shimadzu ud-150b-10 error message
December 11, 2012 06:27
KV Fault, Arc in Tube ??? Transformer HV ?? HV Cable connector in tube without isolation ?.
Good Luck.
to rate and post a comment
Russell Wake
re: shimadzu ud-150b-10 error message
December 11, 2012 01:56
sorry that was f7
to rate and post a comment
Fysares Delali
re: re: shimadzu ud-150b-10 error message
December 14, 2012 12:36
I need service manual or tube replacement manuals...Please contact me fysares@hotmail.com
to rate and post a comment