I have a working Cypress Rev 12.00 and non working Cypress REV 12.00. I have interchanged beamformer and TX/RX ro test these two boards. After fixing back the boards to their respective machines, probe Image is not coming.
Any code or EPROM data got corrupted.
Lakshmi Narayana
Siemens Cypress problem
January 24, 2013 09:35
I have a working Cypress Rev 12.00 and non working Cypress REV 12.00. I have interchanged beamformer and TX/RX ro test these two boards. After fixing back the boards to their respective machines, probe Image is not coming.
Any code or EPROM data got corrupted.
to rate and post a comment
mohamed elgenidy
re: Siemens Cypress problem
January 24, 2013 06:01
what do u find when u turn the machine on?
to rate and post a comment
S K SONI
re: re: Siemens Cypress problem
January 25, 2013 02:53
After turning on the machine do you get any error
to rate and post a comment
Lakshmi Narayana
re: re: Siemens Cypress problem
January 26, 2013 10:20
No error. Machine is booting normally, ultrasound image is not displayed.
to rate and post a comment
mohamed elgenidy
re: re: re: Siemens Cypress problem
January 26, 2013 02:38
u r sure that the probe is connected?is its name is available on the monitor?
to rate and post a comment
Lakshmi Narayana
re: re: re: re: Siemens Cypress problem
February 01, 2013 04:45
Probe is connected but name is not displayed in the monitor. Even the serial no of the Beam former, TX/RX is not diplayed in the settings.
to rate and post a comment
zhang hongjun
re: re: re: re: re: Siemens Cypress problem
February 02, 2013 03:22
Please measure the dc voltegs fist.
to rate and post a comment
Lakshmi Narayana
re: re: re: re: re: re: Siemens Cypress problem
February 04, 2013 10:33
All the DC voltages are normal.
to rate and post a comment