when the start the machine a error giving,writing on the screen error 25,27,28
hit (cr) enter to service menu.
how is the service menu?
or what is the problem.
i mean a cmos ram clerad on the ico3 board because some body opened the system case.
now machine is not working.
i put the a othet machine ico3 board and hdd driver then system normaly worked.
how can load the software or what can i do????
If you removed the metal panel from the card cage without having "Third Party Service" enabled, then the only way to fix the system is to reload software or get a Siemens password to reset the system. In the United States and many other countries, Siemens will provide a software installer MO disk that is specific to your serial number.
You will have to call Siemens to fix this.
The Sequoia has sensors on the system case so if they are triggered you will need a password to reset them.
This password changes every day and only Siemens has it...
So all service has to be done by Siemens...
In order to access the service menu you will need this password and power up the system holding this two keys [multihertz up]+[s] (It will appear in the display Keys detected:15 b0).
This errors you have are:
25 - Test TX1 VGain Slot1
27 - Test PPS control status lines
28 - Test TX1 PWG registers Slot 1
kenan celik
Siemens Sequoıa Problem
March 18, 2008 06:59
when the start the machine a error giving,writing on the screen error 25,27,28
hit (cr) enter to service menu.
how is the service menu?
or what is the problem.
i mean a cmos ram clerad on the ico3 board because some body opened the system case.
now machine is not working.
i put the a othet machine ico3 board and hdd driver then system normaly worked.
how can load the software or what can i do????
to rate and post a comment
Jim Carr
Re: Siemens Sequoıa Problem
March 18, 2008 04:57
If you removed the metal panel from the card cage without having "Third Party Service" enabled, then the only way to fix the system is to reload software or get a Siemens password to reset the system. In the United States and many other countries, Siemens will provide a software installer MO disk that is specific to your serial number.
to rate and post a comment
Emerson Freire
Re: Siemens Sequoıa Problem
March 18, 2008 05:00
Dear Kenan,
You will have to call Siemens to fix this.
The Sequoia has sensors on the system case so if they are triggered you will need a password to reset them.
This password changes every day and only Siemens has it...
So all service has to be done by Siemens...
In order to access the service menu you will need this password and power up the system holding this two keys [multihertz up]+[s] (It will appear in the display Keys detected:15 b0).
This errors you have are:
25 - Test TX1 VGain Slot1
27 - Test PPS control status lines
28 - Test TX1 PWG registers Slot 1
All of them relate to the CN board....
I hope this helped...
Best Regards,
Emerson.
to rate and post a comment
manuel valdez
Re: Siemens Sequoıa Problem
February 14, 2012 07:39
Dear Emerson i have the same problem i am from mexico how i can cantact to siemens? any email?
thanks and best regards
to rate and post a comment
Fred Fimbres
Re: Siemens Sequoıa Problem
February 15, 2012 09:34
Manuel, buenos dias. Please contact me, we might be able to help you with this problem.
Saludos;
Fred Fimbres
UltraSelect Medical LLC.
ffimbres@ultraselectmed.com
to rate and post a comment