Looking for help with a difficult Siemens Symphony Maestro class fault.
The system is booting up fine and passing tuneup. However receive path calibration fails. I have tried two known working head coils, different ports on the table and a software reload. Still the same problem. Hardware test of the receive path pass in test tools.
Any thoughts on what may be the cause would be greatly appreciated.
Altima will inspire the trust, loyalty and commitment of our customers through positive relationships and collaboration, top quality equipment services, and a clearly superior value proposition. Call Today (469) 644-7063
WG
Siemens Symphony Maestro Class Problem
August 18, 2018 02:53
Looking for help with a difficult Siemens Symphony Maestro class fault.
The system is booting up fine and passing tuneup. However receive path calibration fails. I have tried two known working head coils, different ports on the table and a software reload. Still the same problem. Hardware test of the receive path pass in test tools.
Any thoughts on what may be the cause would be greatly appreciated.
to rate and post a comment
Gary Provenzano
re: Siemens Symphony Maestro Class Problem
August 19, 2018 09:38
Look in session history, probable high noise, rf room?
to rate and post a comment
Vijay Sharma
re: Siemens Symphony Maestro Class Problem
August 19, 2018 09:38
What error message are you getting while receive path calibration falling..
to rate and post a comment