Reboot the system and check functionality.
If this message continues to occur:
1. Check the Event Log's application domain for US_IMG_XX messages
and any further information or hints.
2. Extract to file and return to Uptime Support Center or with failed part.
(see Information Section for file format rules.)
3. Measure all power supply outputs for proper level.
4. Run diagnostic test to determine hardware defects.
5. Backup the 'log' directory to CD-R and send back with failed part.
This error indicates that the Imaging software was unable to fully construct itself during booting. If this error was due to a hardware problem, then an
additional message should appear in the event log indicating the
hardware problem.
This error indicates a hardware problem, possibly the lack of any output voltages from the power supply. There should be additional clarifying messages in the event logs indicating a specific hardware error.
BMI-PMI services nearly every make, model, and modality through our nationwide team of nearly 200 local service engineers. Flexible contracts, 24/7 remote monitoring, and ISO 13485 certification. www.brownsmedicalimaging.com / 800-701-9729
Tatiana Bautista
Siemens x300 system error help
June 16, 2021 02:08
hi, please help, on screen appear System error, translation code here, service ID US_IMG_33, image iniatilization failed, any idea, thanks
to rate and post a comment
Rauf Sadikhov
re: Siemens x300 system error help
June 21, 2021 10:44
ID US_IMG_33
Reboot the system and check functionality.
If this message continues to occur:
1. Check the Event Log's application domain for US_IMG_XX messages
and any further information or hints.
2. Extract to file and return to Uptime Support Center or with failed part.
(see Information Section for file format rules.)
3. Measure all power supply outputs for proper level.
4. Run diagnostic test to determine hardware defects.
5. Backup the 'log' directory to CD-R and send back with failed part.
This error indicates that the Imaging software was unable to fully construct itself during booting. If this error was due to a hardware problem, then an
additional message should appear in the event log indicating the
hardware problem.
to rate and post a comment
Ramil Cortes
re: Siemens x300 system error help
June 21, 2021 11:36
Have you tried to reinstall software?
to rate and post a comment
Rauf Sadikhov
re: Siemens x300 system error help
June 21, 2021 11:40
This error indicates a hardware problem, possibly the lack of any output voltages from the power supply. There should be additional clarifying messages in the event logs indicating a specific hardware error.
to rate and post a comment