I have a Sireskop CX that will not tilt the table. Also the table top will only move a few inches before it stops and will not move again. At start up, Iam getting errors in the Kv/mA/mAs windows as follows:
mAs: 866
ms: 16
mAs: 258
ms: 32
I do not have service manual and need to locate one.
We supply high-quality refurbished and used imaging equipment and parts to hospitals, imaging centers, and brokers worldwide. We pay top dollar and offer installation, deinstallation, service, and transport. Se habla español info@medilabglobal.com
Kim Schofield
Sireskop CX Table problem
June 13, 2013 08:30
I have a Sireskop CX that will not tilt the table. Also the table top will only move a few inches before it stops and will not move again. At start up, Iam getting errors in the Kv/mA/mAs windows as follows:
mAs: 866
ms: 16
mAs: 258
ms: 32
I do not have service manual and need to locate one.
Thanks
to rate and post a comment
Lenny Place
re: Sireskop CX Table problem
June 14, 2013 07:13
send me a email address, 32/258 could indicate a bad potentiometer or calibration the 16/866 is normally a videomed issue
to rate and post a comment
Juan de la Cruz Martinez
re: Sireskop CX Table problem
June 14, 2013 07:16
Does it have an overhead? ( 3D), if it does make sure it's on the park position.
to rate and post a comment
Kim Schofield
re: re: Sireskop CX Table problem
June 15, 2013 07:29
Yes, it does have an overhead tube
to rate and post a comment