DETAILED DESCRIPTION
-----------------------------------
The angle position (in reading header) is outside of tolerance
REASONS FOR ERROR
-------------------------------
- The angle speed is too high or low
- Data transfer error receiver -- data I/O
- Data transfer error transmitter -- receiver
- Hardware problem ROSY, DAB, ROT
- Hangup of pipeline (raw data)
- Transmission error on DMS Data slipring
- The data cabl is broken, or demaged, or the casing is hurt,
or the connectors are not coupled correctly
I have a problem in SOMATOM AR STAR, with the same error displays DC_IMPUT_ERROR when preparing to initiate a review, see the contactor of the PDU power comes and goes quickly, I see the error code and post soon after. Thank you.
Divi Srinivas
SOMATOM AR STAR PROBLEM
March 16, 2013 10:14
CAN ANYBODY MAKE SUGGESTIONS FOR THE ERROR OF SOMATOM AR STAR CT SCNNAER: ERROR message as follows
EI 1002 ANGLE WRONG
thanks in advance
to rate and post a comment
SaleSk
re: SOMATOM AR STAR PROBLEM
March 16, 2013 08:47
Check slot ring of AP-Encoder (dust ?)
to rate and post a comment
Imad Muati
re: SOMATOM AR STAR PROBLEM
March 17, 2013 12:45
DETAILED DESCRIPTION
-----------------------------------
The angle position (in reading header) is outside of tolerance
REASONS FOR ERROR
-------------------------------
- The angle speed is too high or low
- Data transfer error receiver -- data I/O
- Data transfer error transmitter -- receiver
- Hardware problem ROSY, DAB, ROT
- Hangup of pipeline (raw data)
- Transmission error on DMS Data slipring
- The data cabl is broken, or demaged, or the casing is hurt,
or the connectors are not coupled correctly
Check slot ring of AP-Encoder (dust ?)
to rate and post a comment
saju
re: re: SOMATOM AR STAR PROBLEM
March 21, 2013 03:58
take blower .open the gantry and blow air towards the centre ring all around.
to rate and post a comment
ROBERTO FURTADO
re: SOMATOM AR STAR PROBLEM
June 21, 2013 10:07
I have a problem in SOMATOM AR STAR, with the same error displays DC_IMPUT_ERROR when preparing to initiate a review, see the contactor of the PDU power comes and goes quickly, I see the error code and post soon after. Thank you.
to rate and post a comment