Hello,
When i try to do a warmup, in the first scan appears err 151 scan timeout error, shortage of DAS DATA.
When i do a pilot, the pilot is displayed o.k. as image.
but i can´t do axial scans, only appears the 151 error.
Does anyone help me with??
thank you in advance.
The gantry rotates fine, but sometime the generator does not send x ray, i need to reset generator for make x rays, i think the problem can be in generator processor, because sometimes the systems performs all scans but without x rays, and without erros, only the 151 error.......what do you think??
The gantry rotates o.k. in manual mode in all speeds without errors.
Abel Cardona
Sytec 4000 err 151 scan timeout
December 22, 2009 10:25
Hello,
When i try to do a warmup, in the first scan appears err 151 scan timeout error, shortage of DAS DATA.
When i do a pilot, the pilot is displayed o.k. as image.
but i can´t do axial scans, only appears the 151 error.
Does anyone help me with??
thank you in advance.
Abel.
to rate and post a comment
JIFFY PAUL AKKARAKARAN
Re: Sytec 4000 err 151 scan timeout
December 23, 2009 09:21
Dear Abel,
did you check whether the gantry is rotating when you give axial scan. If not check the servo amp. rotation power etc
Jiffy
to rate and post a comment
Abel Cardona
Re: Sytec 4000 err 151 scan timeout
December 23, 2009 12:02
Dear Jiffy,
thank you for your reply,
The gantry rotates fine, but sometime the generator does not send x ray, i need to reset generator for make x rays, i think the problem can be in generator processor, because sometimes the systems performs all scans but without x rays, and without erros, only the 151 error.......what do you think??
The gantry rotates o.k. in manual mode in all speeds without errors.
thank you
Abel.
to rate and post a comment
Jose Eduardo Martinez
Re: Sytec 4000 err 151 scan timeout
February 12, 2010 02:16
buen dia
doyou need help yet?
eduardo
to rate and post a comment