Hi everybody,
We have vivid3 that doesnt bootup. the onoff button on kB is lit. after pressing On, the system funs and lEDs on BEP and FE are lit, DVD lit, but the screen stay balck. I have tested the Screen with my laptop the VGA display ok. I tried to boot from CD sw but nothing on screen, i have tested the HDD is ok.
any Idea? Thank you!
regards,
Imeng
You must to check the Front End DC Power Supply (LVPS), check for a VDR burnt, dissconnect the cable PC2IP from PC2IP board and check if the monitor doesn't remains black(with video signal on it)the fault is the LVPS, if remaind black check on the BEP.
Good Luck.
HIGH QUALITY fully tested & refurbished systems to manufacturer specifications like new. Installation & service support worldwide. Parts & tubes in stock with warranty. Sales@Elsmed.com
imeng
US vivid3
September 25, 2014 10:23
Hi everybody,
We have vivid3 that doesnt bootup. the onoff button on kB is lit. after pressing On, the system funs and lEDs on BEP and FE are lit, DVD lit, but the screen stay balck. I have tested the Screen with my laptop the VGA display ok. I tried to boot from CD sw but nothing on screen, i have tested the HDD is ok.
any Idea? Thank you!
regards,
Imeng
to rate and post a comment
Tiorico_86
re: US vivid3
September 26, 2014 10:11
You must to check the Front End DC Power Supply (LVPS), check for a VDR burnt, dissconnect the cable PC2IP from PC2IP board and check if the monitor doesn't remains black(with video signal on it)the fault is the LVPS, if remaind black check on the BEP.
Good Luck.
to rate and post a comment
CHRIS NALMPANTIS
re: US vivid3
September 26, 2014 10:14
this sounds like motherboard from pc. try to change it.It is a INTEL D845EPI/D845GVSR
to rate and post a comment