Hello, dear forum.
I am looking for help to fix an AMX-4 system. When i try to release a x-ray shot, system shows "X-RAY DISABLE". A blown fuse was found in ROTOR CONTROL board, it was already replace, but again was blown when tried another x-ray release. ROTOR CONTROL was replaced, and filament current was calibrated, but system worked just one day after that. X-RAY DISABLED stays on message display. What could be the cause? Do you have any suggestion?
BMI-PMI services nearly every make, model, and modality through our nationwide team of nearly 200 local service engineers. Flexible contracts, 24/7 remote monitoring, and ISO 13485 certification. www.brownsmedicalimaging.com / 800-701-9729
AnyFE
X-RAY DISABLED
September 13, 2022 09:55
Hello, dear forum.
I am looking for help to fix an AMX-4 system. When i try to release a x-ray shot, system shows "X-RAY DISABLE". A blown fuse was found in ROTOR CONTROL board, it was already replace, but again was blown when tried another x-ray release. ROTOR CONTROL was replaced, and filament current was calibrated, but system worked just one day after that. X-RAY DISABLED stays on message display. What could be the cause? Do you have any suggestion?
to rate and post a comment