X-ray Machine cannot do exposure

First let's go back to basics. To get an exposure you must have filament /rotor then high voltage in that order. If you are not getting a rotor then start there. If it is a single phase machine you should have full line voltage on the rotor in "prep" then 50 to 60 vac after about 1.5 seconds in "run" as long as you hold the. Prep button down. If you don't have this then troubleshoot your rotor circuit. You will not get an exposure if the machine does not drop into "run" If the voltages are there then suspect the tube stator. You also might check the presence of filament to the tube by dropping the collimator and visually checking the filament lighting up during "prep". Sometimes you can see. The filament. Lighting up. By turning. The lights out and looking into. The collimator with the blades. Open.. I assume you have checked all the obvious things like blown fuses. Also bypassing things such as exposure hold with automatic collimating and buckys.These are generic tests good for about any system. Good luck.

Yes Radspeed X-ray, pls answer this question,
1) have you look into the focus port?
2) Does the filament present ?
3) Do the tubes rotating wen pressing the prep button ?
4)Does the raedy glow on the console hater pressing the prep button?

5) Does the filament boost wen it rotates?
Contact me @ tayoajakaiye02@gmail.com

Dear Sir,
I have all manuals for this system,
if you need it contact me,
magmesme@gmail.com
also i have good experience in this machine contact me, to trouble shooting this problem,
Regards